Sample Preparation
Sample Amount Required
- For each assay, we ask that you try to send in at least
5 µg of total RNA. Please transfer your sample to a 1.5ml microcentrifuge tube for shipment (0.5 ml or smaller PCR tubes can crack
when frozen).
- We prefer that you send total RNA but if you have already done the enrichment/purification for small RNA, that is OK. We ask that you try to send in at least 2 µg of enriched small RNA.
- If you have difficulty in obtaining the above quantities, please talk to our customer support. We may accept certain smaller quantities on a trial basis. In
this case, we will prepare your samples and measure the processed RNA quantity before hybridization. If not sufficient amount is produced from the preparation, we will notify you to send in
additional materials.
RNA Extraction
- It is very important to use a total RNA preparation procedure that does not remove the low molecular weight RNA fractions.
- We recommend you to use one of the several commercially available RNA extraction kits that are specifically developed for small RNA or microRNA studies. Please refer to corresponding manufacturer's manuals.
Use only one type of extraction kit for all the samples of your project. If this is your first time to perform total RNA extraction for a
small RNA study or if you do not already have a preference for the extraction kit, we recommend the use of
miRNeasy Mini Kit from Qiagen. Please make sure to choose “miRNeasy” and NOT “RNeasy”.
- Many laboratories have obtained excellent results from total RNA samples extracted using Trizol methods. However, skills, experiences and sometime sample types may become critical
factors in obtaining consistently good sample qualities. According to our statistics, the method has an overall higher failure rate than column-based commercial methods, although the
rate varies among different laboratories. If you must use a Trizol method, we recommend modifying precipitation step by doubling the usual isopropanol volume and leaving the RNA at
-80°C for 10-20 minutes so as to ensure the precipitation of small nucleic acids. Some laboratories perform the precipitation step twice and/or perform a post-precipitation
wash twice in order to clean up the sample. You will need to perform some tests in order to find a proper protocol for your sample.
- There is no need to perform a small RNA enrichment step. We will perform small RNA enrichment in our own lab when we receive your sample. We can accept fractionated microRNA but in this
case, certain controls can not be included in your experiment.
- Please transfer your sample to a 1.5ml microcentrifuge tube for shipment (smaller tubes can crack when frozen).
Quality Control of RNA Sample
- A quality control check of your total RNA sample is included in our "Total RNA to Data" comprehensive service.
- If desired, you can check for the presence of small RNAs prior to sending the sample to us using the Agilent Bioanalyzer or by running PAGE. Expect to see a band around ~79 nt.
- Additionally, you can check the UV spectrum of your sample with a spectrophotometer. The 260nm/230nm ratio should be greater than 1.0 and the 260nm/280nm ratio should be above 1.8.
Placing Your Order
Determine Array Content and Select Services
- The probe content of these discovery microarrays is completely customer defined. The flexible
µParaflo®
microfluidic chip technology
enables us to produce custom synthesized microarrays when ordered. (vs. an off-the-shelf spotted array) Therefore, you can add any sequence of your design to our small ncRNA discovery microarrays.
Contact us if you need assistance with array design.
- Based on the objectives of your experiment, select either single sample or dual sample array option. See the
pricing page for a description of each option.
- Select any additional services (such as rush service or in-depth data analysis).
Complete a Sample Submission Form
- Complete a
sample submission form
prior to sending your sample to us.
- The form can be emailed to us at:
sales@lcsciences.com
beforehand or sent in the package along with your sample. Note - If you send the form in the package with samples please place it in a separate waterproof bag.
Packaging and Shipping
- Please transfer your sample to a 1.5ml microcentrifuge tube for shipment (0.5 ml or smaller PCR tubes can crack when frozen). Be sure the tube labels match those listed on your sample submission form.
- If you want to seal the tubes or hold them in a rack, please don't use tape (it will crack when frozen), use parafilm.
- Pack the sample with dry ice in a thermal insulated shipping box.
- Ship the package by overnight carrier for delivery the next day.
- Note - Do not ship samples on Friday as they will sit over the week-end and deteriorate. Wait until the following Monday and ship for Tuesday delivery.
Mail the package to:
Attn: Sample Receiving
LC Sciences
2575 West Bellfort St., Suite 270
Houston, TX 77054
|
